|
|
|
 The shirts. The buttons. The capes. That feeling you get when you first glimpse the arena and all the empty pits, and the only thing is promise. When the last bit of confetti has fallen, and nobody leaves the field.
We are fortunate. - Taylor [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
CIM-U-LATOR CAD file
I drafted Banebots' CIM-U-LATOR so my team (708) could include it on our robot, and we thought we would share it with the general FRC community. Enjoy
 Last edited by Talks Too Much : 18-01-2012 at 11:21. |
|
#3
22-01-2012, 09:18
|
||||
|
||||
Re: CIM-U-LATOR CAD file
Thanks for posting it. We are in the process of order 2 of these units this week.
|
|
#4
22-01-2012, 11:08
|
|||
|
|||
|
Re: CIM-U-LATOR CAD file
Absolutely! Here's a STEP file of the whole assembly. I'm still new to CAD, so tell me if you have any problems with it.
|
|
#5
22-01-2012, 14:53
|
||||
|
||||
|
Re: CIM-U-LATOR CAD file
Imported fine! Just a couple of face repairs needed on one of the parts, but SW took care of this automatically. Thanks for sharing!
One minor question: the Banebots webpage info says that the #10-32 mounting hole pattern on the top of the two plates should form a .75x.75 square when assembled. The dimensions in your model are slightly different. Are your dimensions based off measurements? |
|
#6
22-01-2012, 20:59
|
|||
|
|||
|
Re: CIM-U-LATOR CAD file
Yes, I used the measurements I took of a CIM-U-LATOR we had on hand.
|
|
#7
07-02-2012, 22:06
|
||||
|
||||
|
Re: CIM-U-LATOR CAD file
Talks Too Much is now my favorite user on CD.
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
