FRC Drive Station help. No robot code!

[tap13]

Hello!
I'm totally new at the forum, so please be nice...
We're having problem loading the robot codes to the cRio..
We're using Windriver, C++..
We're using an ethernet cable to connect to the cRio
here's a screenshot
[spoiler]
[/spoiler]
Can you please give down any suggestions to fix our problem
Much help is appreciated!

[Glen]

I would try formatting the cRIO with the FRC 2012 cRIO Imaging Tool. When you do so, make sure that you select Windriver c++ as the option. Once you have done that, try compiling and deploying your Windriver c++ code to the cRIO.

[tap13]

Originally Posted by Glen

I would try formatting the cRIO with the FRC 2012 cRIO Imaging Tool. When you do so, make sure that you select Windriver c++ as the option. Once you have done that, try compiling and deploying your Windriver c++ code to the cRIO.

Problem still persist

[codes02]

Can you be more explicit about what the "problem" is? I see from the screen shot that the "Robot Code" light is red in the driver station. Is there anything wrong with the output from downloading the code? Similarly, is does the imaging tool complain at all?

[Kyler Hagler]

Have you tried this?

http://www.usfirst.org/sites/default...structions.pdf

[charrisTTI]

Make sure firewall is off on DS computer.
Turn off wireless adapter on DS computer.

Has ribbon cable been checked for improper assembly? From the picture it appears that this is one of the cables that needs to be reworked. See article on KOP Control System web page. http://www.usfirst.org/sites/default...structions.pdf

[Chiller]

Originally Posted by charrisTTI

Has ribbon cable been checked for improper assembly? From the picture it appears that this is one of the cables that needs to be reworked. See article on KOP Control System web page. http://www.usfirst.org/sites/default...structions.pdf

This would make no difference, as to only sending signals to the Digital Side Car. When you deploy the code is it loading onto to the robot? Are you using the YELLOW crossover cable? Are you sure you changed your computers ip to whatever it is suppost to be? Same with the subnet: 255.0.0.0? Turned off the firewall?

[tap13]

We fixed it it, thanks for the replies!

[Chiller]

Originally Posted by tap13

We fixed it it, thanks for the replies!

Great explanation on how you managed to do it!

[tap13]

yeah, it was actually the codes, we were loading the wrong codes...

[pmuller]

Could you describe what you mean by the wrong codes? I am having a similar problem. Thanks. -Paul

[eddie12390]

Assuming that you are using C++, remember to reboot the robot each time that you load your code. (Java should do this for you)

Also, make sure to check that you don't have an incorrectly assembled ribbon cable. That will cause a TON of really odd and inexplicable problems.