|
|
|
 As for Dave and the stairs, just ignore him like the rest of the FRC GDC does... ;) - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| As for Dave and the stairs, just ignore him like the rest of the FRC GDC does... ;) - Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Course tolerances
Posted by Erik Justen.
Engineer on team #128, Cold Fusion, from Grandview Heights and The Ohio State University/American Electric Power. Posted on 2/7/2000 10:23 PM MST Someone posted this a while ago, but I couldn't seem to find it. Does anyone know where I can find tolerances for the course dimensions? Someone specified +/- 1 inch, but I can't seem to find that number anywhere in the documentation. Can anyone point me in the right direction? Thanks, Erik |
|
#2
23-06-2002, 23:04
|
|||
|
|||
|
Re: Course tolerances
Posted by Nate Smith.
Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain. Posted on 2/8/2000 8:32 AM MST In Reply to: Course tolerances posted by Erik Justen on 2/7/2000 10:23 PM MST: It is +/- 1 inch, and is noted on the blueprints for the playing field available at www.usfirst.org/2000comp/ |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Units for Pipe Measurements | l1jmx | Rules/Strategy | 4 | 10-01-2002 20:33 |
Hybrid Mode
