|
|
|
 First off, let me suggest that you read the rules! There is an amazing amount of really good information in them. - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| First off, let me suggest that you read the rules! There is an amazing amount of really good information in them. - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
2013 DAP 1522 Rev B1 Firmware
Hello all,
Just a note to say that when I went to use the 2013 FRC Bridge Configuration on the RevB1 Dap1522 bridges, I had issues. I first got a message saying that the firmware was illegal fresh out of the box (FW 2.02), but FW 2.03 works. Also, I found that in 2.4 GHz mode, it would not work, but does in 5 GHz mode. Hope this helps. 
|
|
#2
07-01-2013, 23:09
|
||||
|
||||
|
Re: 2013 DAP 1522 Rev B1 Firmware
compboy07 posted the solution in this thread: http://www.chiefdelphi.com/forums/sh...rmware+illegal
Specifically, this post: http://www.chiefdelphi.com/forums/sh...80&postcount=3 With the solution that you found, the classmate does not support a 5GHz signal, like most other computers. So you may not be able to connect to your robot. I would recommend downgrading the firmware to 2.00 as shown in the post I linked.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
