|
|
|
 Just a modest request for folks NOT to put 3000-pixel-wide pictures inline in the forum. A link to the big picture works just as well while keeping the text readable. Thanks. - Rick TYler [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
D-Link Bridge Communication
I hooked up the D-Link to the cRIO, and everything does seem to work. However, every time I disconnect and stop controlling the robot wirelessly. I have to relaunch the FRC Bridge Configuration Utility in order to reconnect and redeploy. Does anyone know why this is? Thanks!
Allons-y 
|
|
#2
14-01-2013, 17:46
|
|||||
|
|||||
|
Re: D-Link Bridge Communication
Check what your IP address/netmask are on your laptop before and after running as well as before and after using the Bridge Config Utility.
For that matter try browsing to the bridge before and after to see what IP is in use there. I think the Bridge Config. Utility may be leaving your laptop IP as 192.168.0.51. Then if your Driver Station is already running, it won't be able to connect to the cRIO. Is your Driver Station set to change your laptop IP automatically whenever it is started? Last edited by Mark McLeod : 14-01-2013 at 17:48.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
