Volts Problem

[Avihu]

hello
when we run the program on our robot the volts Values stays on 0.00 .. what could be the problem?

[MrForbes]

You probably either did not connect the wires from the power distribution board to the analog bumper, or you did not add the jumper on the analog bumper.

[Avihu]

umm.. where does the jumer goes? I mean on the analog there are several pins..
wich should i use/cover..?

[MrForbes]

R71 in the Game Manual.

[Jon Stratis]

In the picture on the first page here you'll see the entire analog breakout. In the top left corner of the image there are 3 exposed pins, spaced so they would fit a normal PWM wire. Place a 2-pin jumper over the two pins on the left of the picture - in other words, the two pins closest to the side edge of the board.