PWM Not going to full on

[derekogle37]

So I'm using the the set function of the victor class to control a motor, when I pass -1 to the function, the motor goes in full reverse no problem and the victor indicator light goes red. But when I pass 1 as the parameter the motor goes to full speed (or what appears to be), but the green light will not come on on the victor. I've tried putting in a larger value such as 3 or 4 and even 255 but it will not accelerate further nor will the green light come on. To confirm that it was not the controller I switched back to using the robotdrive class with the tankdrive function, and it had no problem going full forward with the green indicator light coming on. I also tried a few different controllers and PWM ports with the same results.

Basically my code is

//Definition section
Victor* motorlaunch;
//Constructor section
motorlaunch = new Victor(1,3);
//Teleop section
motorlaunch->Set(1);

[Ether]

Try calibrating that Victor.

[Team3266Spencer]

Originally Posted by Ether

Try calibrating that Victor.

Full support of this action. (Y)

[derekogle37]

Worked perfectly, thanks a lot!