|
|
|
 What Delphi says doesn't matter. What the official Q&A says matters. - Tetraman [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| What Delphi says doesn't matter. What the official Q&A says matters. - Tetraman [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
E4P encoder scale
Does anyone know if there is a set scale somewhere for the E4P encoder? We have it hooked up to an Andymark gearbox with a CIM motor, and we would like to know if we have to measure the correlation between time spinning, rate of rotation, and number of rotations?
|
|
#2
07-02-2013, 16:48
|
|||||
|
|||||
|
Re: E4P encoder scale
If it has a "360" in its part number, it has 360 counts per revolution. If it has "250" twice, it has 250 counts per revolution. (The other 250 means it's meant to fit a quarter-inch shaft.)
Some people prefer the term "cycles" instead of "counts".
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
