Gyro angle will not work with robot code

[AquaMorph]

I am trying to get an angle from the gyro and I am able to get the sample code to work. But when I try to use the sample code on the robot code it just outputs a constantly increasing number from 0-360. I attached the code below. Can anyone tell me why this is happening?

[Mark McLeod]

You didn't set the gyro gain. Try this:

[AquaMorph]

Originally Posted by Mark McLeod

You didn't set the gyro gain. Try this:

I copied your code and it is still constantly increase but this time by a smaller number.

[Mark McLeod]

The spec sheet for the gyro you are using should list a value for "voltage per degree of rotation per second", use the value they list for the gain.

When the cRIO is first booted, you know you must not touch the robot while the gyro initializes?
That's how it decides what zero is.

[Ether]

Originally Posted by AquaMorph

I copied your code and it is still constantly increase but this time by a smaller number.

How small? Is it of the order of 1 degree every 2 minutes or so? If so, that would be normal drift for KoP gyro.

[AquaMorph]

Originally Posted by Ether

How small? Is it of the order of 1 degree every 2 minutes or so? If so, that would be normal drift for KoP gyro.

It is to the forth decimal place and moving the gyro doesn't do anything.

[Ether]

Originally Posted by AquaMorph

It is to the forth decimal place and moving the gyro doesn't do anything.

Post a photo of how you have it wired. Show both the gyro end and the other end of the cable. Please use the macro setting on your camera for close-ups.

[AquaMorph]

Originally Posted by Ether

Post a photo of how you have it wired. Show both the gyro end and the other end of the cable. Please use the macro setting on your camera for close-ups.

I can't take a picture of it until tonight. However, I know the wiring is correct because I loaded the sample code on the robot and it ran fine and gave me the angles I wanted.

[Ether]

Originally Posted by AquaMorph

I can't take a picture of it until tonight. However, I know the wiring is correct because I loaded the sample code on the robot and it ran fine and gave me the angles I wanted.

We should have asked you right at the start what was your intended use for the gyro.

I just saw on another thread that you are intending to use the gyro for your shooter altitude angle.

I think you want a potentiometer or encoder instead.

[AquaMorph]

Originally Posted by Ether

We should have asked you right at the start what was your intended use for the gyro.

I just saw on another thread that you are intending to use the gyro for your shooter altitude angle.

I think you want a potentiometer or encoder instead.

I think an encoder would work best. I don't think a potentiometer came in the KOP. Do you have an idea of what would be best for a shooter that is going to only moving up and down in a range of 70 degrees?

[Ether]

Originally Posted by AquaMorph

I think an encoder would work best. I don't think a potentiometer came in the KOP. Do you have an idea of what would be best for a shooter that is going to only moving up and down in a range of 70 degrees?

That's a great application for a potentiometer. An encoder would also work.

[AquaMorph]

Originally Posted by Ether

That's a great application for a potentiometer. An encoder would also work.

I don't think I have potentiometer but I can play with an encoder.