'Aluminum Angle/box/tube'-- copy of posting in General

Mentors can always use mentoring. - JaneYoung [more]

		Chief Delphi > Old Forum Archives > 2000
'Aluminum Angle/box/tube'-- copy of posting in General

Thread Tools

Rate Thread

Display Modes

24-06-2002, 00:11

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

'Aluminum Angle/box/tube'-- copy of posting in General

Posted by Joe Johnson.&nbsp;&nbsp;&nbsp;[PICTURE: SAME | NEW | HELP]

Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 10/20/2000 1:29 PM MST

: Question:
: Can extruded aluminum be used?

: Answer:
: Only if it is 'Aluminum Angle/box/tube' or 'Aluminun Plate up to 1/4 inch thick'

: Note, there have been additions to the Additional Hardware List (follow link below). Essentially we've added #35 Chain, Larger PVC Schedule 40 pipe & Springs.

: Joe J.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Casters -- Copy of Post in General	archiver	2000	0	24-06-2002 00:11
Scoring Clarification -- copy of posting in General	archiver	2000	4	24-06-2002 00:11
Out of bounds... -- copy of posting in General	archiver	2000	0	24-06-2002 00:11

All times are GMT -5. The time now is 03:32.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.