Running Two Separate Solenoids off of one Spike

[ShaneKent253]

Hello from Team 253,

We are wondering if we can run two solenoids off of one single spike. That is it, thank you.

Shane

[EricH]

Explicitly allowed by R51.

[jmartin]

Yes, you can, see the note after the table in rule R51:

*Multiple low-load, pneumatic solenoid valves, electric solenoids or CUSTOM CIRCUITS may be connected to a single relay module. This would allow one (1) relay module to drive multiple pneumatic actions or multiple CUSTOM CIRCUITS. No other electrical load can be connected to a relay module used in this manner.

[Ether]

Originally Posted by ShaneKent253

We are wondering if we can run two solenoids off of one single spike. That is it, thank you.

from the Game Manual:

4.8.21 R51

Each power regulating device may control electrical loads per Table 4-4. Unless otherwise noted, each power
regulating device may control one and only one electrical load.

Table 4-4: Legal Power Regulating Device Use

Multiple low-load, pneumatic solenoid valves, electric solenoids or CUSTOM CIRCUITS may be connected to a single
relay module. This would allow one (1) relay module to drive multiple pneumatic actions or multiple CUSTOM
CIRCUITS. No other electrical load can be connected to a relay module used in this manner.