|
|
|
 The answer doesn't lie with an all student run team, or an Engineer-fest team... But somewhere in the middle. Moderation is key. - Cody Carey [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The answer doesn't lie with an all student run team, or an Engineer-fest team... But somewhere in the middle. Moderation is key. - Cody Carey [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
EKOCYCLE
We started making spacers for our hex shaft using our EXOCYCLE 3D printer, custom sizes.
What are you using your EKOCYCLE printer for ? 
|
|
#2
07-02-2015, 23:42
|
|||||
|
|||||
|
Re: EKOCYCLE
We made bearing blocks which will be attached to our wheels that ride the elevator tracks. Honestly its not a bad printer. Im really glad we havent had the same issues we had less year with the original cube 3d. We shall see one batch of 2 is done and looks good 3 to go.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
