Launchpad control panel outputs help

[Sjtumlin16]

How would the labview code be made so that if a limit switch is pressed a light turns on on the control panel which is using a Launchpad, from what i can see the joystick output block only allows 1 non-addressable output to be turned on.
Thanks.

[wt200999]

The joystick output block takes an array of Boolean values to define the output state on the TI LaunchPad.

Here are a couple of examples of setting the outputs with arrays:



If you have a couple of switches, you could do something similar to below:



Note that in my examples above everything is zero indexed (the output names I set start with 0). On the TI LaunchPad documentation the outputs are 1 indexed (the output naming start with 1).

[Sjtumlin16]

Thank you w200999! That's exactly what I needed.