|
|
|
 You should never, EVER bully, manipulate, or slander another team for the sake of winning. - Libby K [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You should never, EVER bully, manipulate, or slander another team for the sake of winning. - Libby K [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Tapped Drill motor holes: thread anyone?
I don't want to re-thread the tapped holes on the front (non-terminal) side of the drill motors, but I can't read the print, it's late, and I don't have the hardware here at home. Can anyone tell me what the thread is on these bad boys? I'm going to figure it out eventually, but the less time I spend hunting for screws to chop down the better. Thanks. -Joe
|
|
#2
16-01-2002, 05:10
|
|||
|
|||
|
The sheet I have, a third or fourth generation copy, calls the tapped holes "2 - M4.0 / Tapped holes". Note 6 says "tapped / holes can accept a maximum usable male screw or pin length of 3.0 mm".
HTH  |
|
#3
16-01-2002, 08:40
|
||||||
|
||||||
|
M4 on the drills, M3 on the Fisher Price, M6 on the window, #10-32 on the Chiaphuas..
FYI.
Joe J. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Remember that thread? [08-19-03] | Ken Leung | General Forum | 5 | 23-08-2003 21:34 |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
| drill motor mounts- again | Jeff Sharpe | Motors | 6 | 07-04-2003 23:20 |
| Emergency drill trade/sell | Anarkissed | General Forum | 3 | 16-02-2003 22:37 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Hybrid Mode
