|
|
|
 Ultrasonic sensors will allow you to do fundamentally the same thing that the bump sensors do...so you can slow down and smoothly stop your robot just before it reaches the end wall, instead of running into it at full speed and then figuring out "ohh! there is a wall there!" - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
question about atwood motor
does anyone know where I can find a 25 degree pressure angle gear to mesh with the output shaft of the atwood motor? (other than the one supplied, of course)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drill motor change out question?? | archiver | 2001 | 9 | 23-06-2002 23:36 |
| Is it weird to see an atwood motor floating in mid air? | mnkysp6353 | Chit-Chat | 6 | 19-02-2002 21:38 |
| What's with the New Motor Specs for the Atwood Mobile (Chiaphua) Motor. | Robb Gerber | Motors | 2 | 23-01-2002 08:58 |
| question about atwood motor | matt sorgenfrei | General Forum | 1 | 19-01-2002 08:31 |
| Drill motor gearBox question | Dennis Hughes | Motors | 4 | 11-10-2001 07:11 |
Hybrid Mode
