Spike RED Pinout

[Venkatesh]

I am using a Spike RED module for a project involving a demonstration, of electronic systems. I have searched everywhere, and haven't been able to get the pinout of the control pins for the Spike RED. Does anyone know of where I could find the pinout, or does anyone have it?

Otherwise, Im going to try to determine it experimentally, assuming the black wire is ground. Does a 5V signal as a test input the control pins seem reasonable?

[OddOne]

Try putting a multimeter on the output of the RC to test what kind of output is going to the Spike. I would say they are PWM, but those are the analog outputs on the other side.

[Andy Brockway]

Pin out is the same as the blue spike. Manual for blue spike is on Innovation First's site. I only have a hard copy for the red spike. If there is any info you need let me know.

[Joe Ross]

Andy, he was refering to the inputs from the RC, which the innovation FIRST manuals do not cover.

Venkatesh, you will find the answer in this thread: http://www.chiefdelphi.com/forums/sh...threadid=14026 When you first posted, I had remembered that thread, but couldn't find it. Well, now I finally found it.