|
|
|
 It is proper to have a disagreement, but it is improper to be disrespectful. - Bill Moore [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It is proper to have a disagreement, but it is improper to be disrespectful. - Bill Moore [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
17-05-2003, 20:08
|
||||
|
||||
|
The drill motor has a 15 tooth, Metric Module .7 gear.
There is only one distributor of these within the US (that I know of, does anyone know of more?) http://www.pic-design.com/ |
|
#3
18-05-2003, 09:53
|
|||||
|
|||||
|
Nope, they are the only source that I have found also.
I would recomend ordering a few in the off season since they take a minimum of two weeks to get and they aren't very expensive. This year we used a 48 tooth to lower the drill down to the Atwood and it worked very well as far as power goes. |
|
#4
18-05-2003, 11:51
|
|||
|
|||
|
PIC is all I have ever found either. Stock Drive and Boston do supply metric gears, but not in the module used by the drill motor.
We used the first planetary stage from the drillo motor gearbox with our own custom output axle. This let us use "standard" parts from that point on. Also, the first stage on this gearbox matches the output speed pretty well to the speed of the Chip. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Helical gears that come with new drill motor | Joe P | Technical Discussion | 4 | 12-01-2003 11:09 |
| Best source for gears? Smallparts? drivetrain advice wanted! | Frank(Aflak) | Technical Discussion | 11 | 10-01-2003 17:22 |
| gears....? | archiver | 2000 | 16 | 23-06-2002 22:58 |
| Need help! What kind of gears are we allowed to use?? | Randy_Ai | Technical Discussion | 3 | 23-01-2002 22:56 |
| How do i make gears in inventor? | mnkysp6353 | Inventor | 1 | 16-01-2002 02:31 |
Hybrid Mode
