2002 Motor Measurements

Matt Krass · #1 01-08-2003, 15:58

I need the measurement from the center of the shaft to the furthest outer edge of the Bosch 2002 Drill motor tranny, thanks.

Kevin A · #2 01-08-2003, 18:54

When do you need it by? I can get it to you sometime next week if that would help.

Matt Krass · #3 01-08-2003, 20:37

That would be great, but if anyone can get it faster it'd be appreciated, there is no timelimit but I'm anxious to get back to work

Thanks.

Veselin Kolev · #4 04-08-2003, 21:29

From the documents I have, it's 52 mm in diameter, so 26 mm from the shaft. But I'm not sure if those are the right documents. Why do you need that measurement?

Matt Krass · #5 05-08-2003, 01:28

Can anybody create an assembly of the 2002 Drillmotor and Tranny with the Inventor files available on www.firstcadlibrary.com ? I cannot properly assemble it and I could really use the model. The files I believe are all available in Inventor format under archives.

petek · #6 06-08-2003, 12:20

You can download our motor panel assembly which includes the drill motors & their trannies from Cybersonics' Inventor Award submission . They are in Inventor v5. You can also get them from the FIRST virtual kit of parts (in v6), which is probably still linked from FIRST's site.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2002 California Robot Games	Ken Leung	Off-Season Events	11	28-09-2002 22:05
Ramp Riot 2002, November 2, Updated Information	OZ_341	Off-Season Events	0	05-09-2002 02:40
PUSH to Simplify the Game for 2002 *Attention FIRST *	archiver	2001	37	24-06-2002 03:45
Ramp Riot 2002, Third Annual Off-season Competition	OZ_341	Off-Season Events	0	20-06-2002 12:21
2002 Chairman's Award	Eric Bareiss	Chairman's Award	2	29-09-2001 22:27