Question about input pins.

Tom Bottiglieri · #1 15-02-2004, 14:06

What is the natural state of digital input pins on the RC. My mind tells me low, some documentation says high, and some other CD users say low.

Kevin Watson · #2 15-02-2004, 14:43

Quote:

Originally Posted by ToMMan b182

What is the natural state of digital input pins on the RC. My mind tells me low, some documentation says high, and some other CD users say low.

Each digital I/O has a light pull-up to Vcc. So without anything driving the pin, you'll read a logic 1. It's documented here.

-Kevin

steven114 · #3 15-02-2004, 15:02

If you don't trust their answers, just take a multimeter to it... is it 5v or 0?

Tom Bottiglieri · #4 15-02-2004, 15:12

i would have done that, but im at home right now, writing the program.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems reading io pins as a group	emusteve	Programming	16	13-02-2004 13:42
TTL pins	Dave...	Control System	3	07-02-2004 23:59
A question about control system options	computhief263	Control System	7	04-02-2004 14:46
PBASIC/control system question	archiver	2001	1	24-06-2002 00:33
Rookie Programmer has question about the default code	DanL	Programming	3	26-01-2002 19:59