|
|
|
 Where's my hammer? I need a bigger hammer. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Where's my hammer? I need a bigger hammer. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
A little help?
So I know we have a ton of mech E's that post here. Do any of you use Mechanical dynamics Adams? To be exact Adams/view? I have a few questions and if anyone could help I would owe them KK's for life.
Thanks |
|
#2
01-05-2004, 20:08
|
||||
|
||||
|
Re: A little help?
hmmm.. I think it might help if you told us what Mechanical dynamics Adams is. So far, my answer is no, just because I don't know. Seeing as this is the CAD section, are you refering to a type of CAD softwear?
|
|
#3
03-05-2004, 12:15
|
||||||
|
||||||
|
Re: A little help?
I haven't used Adams except for a demo years ago, but I've used similar programs - if you post or PM your specific question I'll try to find an answer for you. After all, KK's for life are at stake here
 |
|
#4
03-05-2004, 15:34
|
||||
|
||||
|
Re: A little help?
I think I figured out what I was trying to do. Thanks to all for the help.
|
|
#5
03-05-2004, 16:19
|
||||||
|
||||||
|
Re: A little help?
 <stomach grumbles at yet another lost KK opportunity> Glad it worked out. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
