|
|
|
 FIRST has given me too much for me to leave without leaving a mark... - Joe G. [more] |
 |
|
|||||||
|
||||||||
| View Poll Results: What algorithm do you use? | |||
| P |
  
|
2 | 20.00% |
| PI |
  
|
0 | 0% |
| PD |
  
|
1 | 10.00% |
| PID |
  
|
5 | 50.00% |
| Digital |
  
|
1 | 10.00% |
| Other(explain) |
  
|
1 | 10.00% |
| Voters: 10. You may not vote on this poll | |||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
POLL: control loops
For those of you who use feedback control, what algorithms do you use? PID/P/PI/PD? Digital? Fuzzy logic? etc? How fast do you run your loop? What special problems have you encountered? What are you using it for? Speed control? Position control? Load compensation on manipulator?
Last edited by Rickertsen2 : 27-10-2004 at 22:14. |
|
#2
28-10-2004, 19:14
|
||||
|
||||
|
Re: POLL: control loops
Maybie this deserves its own thread, but i am going to put it in this semi-related thread anyway. For those teams that have implemented any sort of controller that has a Integrl ter, how do you handle setpoint changes?
|
|
#3
28-10-2004, 20:32
|
||||
|
||||
|
Re: POLL: control loops
I have not yet tested a PID loop, though I have researched and coded one. Could you explain what different ways there are to handle setpoint changes? Seems to me there is only one way...
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PID control loops - closed loop feedback | KenWittlief | Technical Discussion | 56 | 26-04-2004 21:27 |
| What do you wish you knew about the new control system? | Joe Ross | Control System | 2 | 09-01-2004 21:47 |
| idea: a semi-official coaches poll | archiver | 1999 | 8 | 23-06-2002 22:23 |
| Ok, how much is the control system worth? | archiver | 2001 | 6 | 23-06-2002 22:05 |
| more control options | smokescreen | Technical Discussion | 17 | 05-03-2002 15:41 |
Hybrid Mode
