|
|
|
 While searching is not as glamorous, I'm certain you could find a lot of good resources related to this topic. - Katie_UPS [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| While searching is not as glamorous, I'm certain you could find a lot of good resources related to this topic. - Katie_UPS [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
Victor and PWM Cable Problem
Hi.
When prototyping at tonight's meeting, I stumbled across something: The PWM Cables provided in the kit do not fit the slot for the PWM Cable from the Vic to the FRC.  Has anyone else had this same problem, and if you have, did you just have to notch the existing PWM connector?Thanks in advance. |
|
#2
13-01-2005, 22:58
|
||||
|
||||
|
Re: Victor and PWM Cable Problem
goto this thread
http://www.chiefdelphi.com/forums/sh...ad.php?t=32661 Edit:- Just trim the notches off the victor connector(not the pwm cable  ) |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
