|
|
|
 You guys can send [Wisconsin] some warm Florida weather, its getting cold up here again. - Ricky Q. [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You guys can send [Wisconsin] some warm Florida weather, its getting cold up here again. - Ricky Q. [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
23-01-2005, 15:20
|
|||
|
|||
|
Re: Pitch of Jideco Motor
Has anyone found out the specs of this gear, or how to mate with it? Help would be greatly apprecieated. Specs are best, but other ideas for mating are good too.
|
|
#3
23-01-2005, 17:48
|
|||||
|
|||||
|
Re: Pitch of Jideco Motor
|
|
#4
04-02-2005, 20:37
|
|||||
|
|||||
|
Re: Pitch of Jideco Motor
It looks like the gear on the Jideco is an 8 tooth, mod 2, 30 deg pressure angle. At least that is as close as my poor old eyes could measure. I've attached the Inventor part I made of it.
No guarantees about accuracy, your mileage may vary, do not eat Jideco Gear, etc. When you open the Inventor file the screen will be blank. Grab the End of File marker (red circle with x in it) in the browser and drag it down to the bottom of the browser. The part should then be visible. Save it. (Moving the marker is a trick which reduces the file size dramatically). Last edited by petek : 04-02-2005 at 21:57. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiple Motors | phrontist | Motors | 12 | 21-06-2004 23:05 |
| Mounting the drill motor | Veselin Kolev | Motors | 11 | 26-04-2004 14:27 |
| BOSCH motor pinion pitch | Matt Reiland | Technical Discussion | 2 | 10-01-2003 09:26 |
| Thermal Protection | archiver | 2000 | 1 | 23-06-2002 23:27 |
| Jideco Motor Spec's (wanted) | Larry Barello | Motors | 1 | 15-01-2002 21:58 |
#4
Hybrid Mode
