|
|
|
 Remember, only YOU can set a good examples for rookies to search CD first before asking questions or responding!! - Foster [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Remember, only YOU can set a good examples for rookies to search CD first before asking questions or responding!! - Foster [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
07-10-2005, 23:21
|
|||
|
|||
|
Re: [OCCRA]: drill motor sproket
?? the bolt is reeverse thread.. so you turn clockwise to loosen.... and then the sprocket itself should be regular thread. if you used locktite.. which i reccomend, it might be stiff. but how are you haveing trouble getting it off?
|
|
#3
07-10-2005, 23:46
|
||||
|
||||
|
Re: [OCCRA]: drill motor sproket
Stevie... Are you referring to the gear on the shaft coming directly from the motor itself?
|
|
#4
08-10-2005, 07:22
|
|||
|
|||
|
Re: [OCCRA]: drill motor sproket
as in inside the tranny?
|
|
#5
08-10-2005, 08:54
|
|||||
|
|||||
|
Re: [OCCRA]: drill motor sproket
No, I am talking about the sprocket on the outside of the transmission. I think it is a nine tooth sprocket. I want to take that off to put this thing on there so I can put 3/8" shaft.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: drill transmission | greencactus3 | OCCRA | 4 | 14-10-2004 22:33 |
| [OCCRA]: [OCCRA] drill transmission | greencactus3 | OCCRA Q&A | 1 | 11-10-2004 19:31 |
| [OCCRA]: hose clamps on drill transmissions' gear selector? | greencactus3 | OCCRA Q&A | 1 | 06-10-2004 05:28 |
| Mounting the drill motor | Veselin Kolev | Motors | 11 | 26-04-2004 14:27 |
| Portable cordless drill press | Gui Cavalcanti | Technical Discussion | 25 | 03-08-2003 22:21 |
Hybrid Mode
