|
|
|
 If an alternate is used, all four teams are equal members of the alliance. (Trophies, trips, bling, book tours, custody of the children etc.) - Btower [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If an alternate is used, all four teams are equal members of the alliance. (Trophies, trips, bling, book tours, custody of the children etc.) - Btower [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
FRC analog input RC filter values
I Know this has been mentioned on the forum before but, I can't find it. What are the resistor and capacitor values that are used for the analog input low pass filter? Isn't it set for 400Hz ? Can any one help or point me to a source?
Thanks |
|
#2
01-01-2006, 21:44
|
|||
|
|||
|
Re: FRC analog input RC filter values
I found a schematic on IFI's website. The resistor and cap are 1K and 0.047uF, respectively.
If I recall, the cutoff frequency is 1/(2*pi*R*C). That puts it at 3.4kHz. |
|
#3
01-01-2006, 22:03
|
||||
|
||||
|
Re: FRC analog input RC filter values
out of curiosity, what are you hooking up that you are concerned about bandwidth?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Analog and digital input question | Robby | Control System | 7 | 30-04-2005 20:07 |
| Analog Input Trouble | Matt Krass | Programming | 10 | 20-01-2005 21:09 |
| **FIRST EMAIL**/2005 FRC Game Design Communication to FRC Teams | Goobergunch | FIRST E-Mail Blast Archive | 1 | 06-01-2005 09:29 |
| heres the code. y this not working | omega | Programming | 16 | 31-03-2004 15:18 |
| DC Motor current to an Analog Input | junkyarddawg | Motors | 43 | 04-04-2002 15:53 |
Hybrid Mode
