|
|
|
 I'm somewhat fond of saying, if your robot dosen't weigh 119.99 pounds, you forgot something. - Francis-134 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm somewhat fond of saying, if your robot dosen't weigh 119.99 pounds, you forgot something. - Francis-134 [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
HELP! Can't Program Robot Controller - LED stuck.
when we download the program for the camera from easyc the frc robot controller never comes out of programming state. the programming led constantly blinks orange. we looked for a code error and to see if we hooked it up wrong but we can't find the problem.
~sheyna Last edited by sheyna : 21-01-2006 at 13:33. |
|
#2
21-01-2006, 12:46
|
|||||
|
|||||
|
Re: HELP!!! frc micro controller
First, i would change the title to something like "Can't Program Robot Controller - LED stuck" that will generate a much higher read rate.
Have you downloaded the latest IFI_Loader? are you using the latest C18 compiler? latest MpLab? -Leav |
|
#3
21-01-2006, 14:35
|
|||
|
|||
|
Re: HELP! Can't Program Robot Controller - LED stays on.
This happened to me a few times. The only way I managed to fix it was just to redownload the code again, even if you haven't changed anything.
|
|
#4
21-01-2006, 18:50
|
|||
|
|||
|
Re: HELP! Can't Program Robot Controller - LED stays on.
http://www2.usfirst.org/2006comp/oth...ices_Rev_B.pdf
Check out the bottom of page 29 there. It won't hurt the controller in any way, so it might be a good thing to try. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2003 robot controller & interface | LGuY | Control System | 3 | 04-04-2004 16:01 |
| Possible Robot controller problems | mpalermo81 | Technical Discussion | 1 | 24-02-2004 22:43 |
| Robot Controller Flips Out | Eko | Programming | 6 | 22-02-2004 22:53 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |
Hybrid Mode
