IFI Loader Directions

MSJhippo1965 · #1 04-02-2006, 10:42

Rookie team here!!! Need specific instructions on how to use ifi loader to transfer compiled code to robot controller...ASAP!! Thank you

Joe Ross · #2 04-02-2006, 11:14

When you compile the code, it creates a .hex file.

1. Open IFI loader and click the browse button and select the .hex file you compiled.
2. Connect your computer's serial port to the programming port on the robot controller.
3. Press the program button on the robot controller.
4. Press download on the IFI loader. (It takes a few moments for the code to load).

Ricky Q. · #3 04-02-2006, 13:04

Quote:

Originally Posted by Joe Ross

When you compile the code, it creates a .hex file.

1. Open IFI loader and click the browse button and select the .hex file you compiled.
2. Connect your computer's serial port to the programming port on the robot controller.
3. Press the program button on the robot controller.
4. Press download on the IFI loader. (It takes a few moments for the code to load).

Just a note, hold the program button till the program LED on the RC turns orange, then download.

MSJhippo1965 · #4 06-02-2006, 17:19

Thank you! It really helped! Can't wait to see you at the FIRST competition!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
IFI Loader Reloaded	sciguy125	Programming	26	07-08-2007 00:07
IFI Loader Problem	Master Dictator	General Forum	18	02-02-2006 20:27
IFI Loader and PROG button	Dave...	Programming	3	20-02-2005 12:03
IFI Loader Doc's	Raven_Writer	Programming	0	21-01-2004 17:53
Bug in IFI Loader	rwaliany	Programming	2	06-01-2004 21:26