|
|
|
 why would someone do that? Go on the internet and tell lies? - MaGiC_PiKaChU [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| why would someone do that? Go on the internet and tell lies? - MaGiC_PiKaChU [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Servo Help
Hello,
Can someone please explain the process of how to make the servos on the camera to move the camera. At this point when we try to make the camera track the green light it does not move the servos. It track it in the camera's range, but it does not move to follow it. Is there a certain way to make them work? Thank you in advance for any information. |
|
#2
06-02-2006, 17:53
|
|||
|
|||
|
Re: Servo Help
If you are using Kevin's code, dont forget to plug the servos into the RC [pwm 1 - pan; pwm 2 - tilt by default], and another power connector into a spare pwm port. Make sure you have a fully charged backup battery, and it should work.
good luck |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera Servo Problems | pi_guy578 | Programming | 2 | 28-01-2006 13:17 |
| Servo behavior question / advanced servo/PIC programming question | DanL | Electrical | 12 | 18-10-2005 18:33 |
| Servo command confusion?!?!?!?! | [527]phil | Programming | 9 | 15-07-2005 20:10 |
| Servo Compact Design Problems!!! | Dominator_Legen | Electrical | 22 | 07-04-2005 18:15 |
| Servo Help | Dominator_Legen | Motors | 3 | 11-03-2005 19:50 |
Hybrid Mode
