|
|
|
 I fear not the drive team who has practiced 10,000 defenses once, but I fear the drive team who has practiced one defense 10,000 times. -Bruce Lee - bEdhEd [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I fear not the drive team who has practiced 10,000 defenses once, but I fear the drive team who has practiced one defense 10,000 times. -Bruce Lee - bEdhEd [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
IR Switch Wiring
Can anybody give me some information on how to wire the revieving end of the IR sensors?
|
|
#2
13-02-2006, 21:34
|
|||||
|
|||||
|
Re: IR Switch Wiring
Wire it the way it's labeled on the side of the sensor. Ground the ground wire, put 12 volts (from your 20 amp "sensor power" circuit) on the power wire, and connect either the NC or NO output to a digital input on the Robot Controller.
|
|
#3
14-02-2006, 03:26
|
|||
|
|||
|
Re: IR Switch Wiring
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help Wiring Micro Switch/Limiting Switch | Windward | Electrical | 2 | 07-02-2006 18:26 |
| Wiring Nasson switch | ten3brousone | Pneumatics | 4 | 19-02-2005 17:16 |
| Wiring a switch | stevex | Electrical | 3 | 16-02-2005 08:31 |
| Pressure Switch wiring diagram | robotjoe | Electrical | 1 | 08-02-2005 14:01 |
| LEDs in switch box. | ZZII 527 | Electrical | 5 | 06-03-2004 19:39 |
Hybrid Mode
