|
|
|
 Sometime it makes me think what would I do without FIRST... - Arefin Bari [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Sometime it makes me think what would I do without FIRST... - Arefin Bari [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
pic: 1023 Electronics Board
|
|
#2
13-02-2006, 21:57
|
||||
|
||||
|
Re: pic: 1023 Electronics Board
We used an electronics mounting scheme similar to that last year. 1/4" lexan fits beautifully in the 8020 slot, and you don't need to use any fasteners to keep it in place.
However, I will caution... Be sure to tighten/loctite all the anchor screws on the 8020 connections, and any other mounting hardware that is hidden by the electronics board. We found out the hard way during some elimination rounds, when some "hidden" bolts came loose on our drivetrain. Cut out access points and/or limit the amount of bolts that need to be tightened from the bottom side of the electronics. Looks great overall. I like the use of the smoked lexan. BEN |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 1023 Teaser #1 | KTorak | Robot Showcase | 12 | 21-02-2006 19:54 |
| pic: 701 Electronics Board | Doug G | Robot Showcase | 19 | 13-02-2006 19:40 |
| pic: #1156 Under Control [Brazil] - Electrical components board | Daniel_H | Extra Discussion | 6 | 30-01-2005 19:56 |
| pic: 1382 Brazil Prototype + Electronic Board | tribotec_ca88 | Extra Discussion | 1 | 29-01-2005 15:54 |
| Electronics Board Construction/Design | zdeswarte | Electrical | 10 | 28-01-2005 00:09 |
Hybrid Mode
