|
|
|
 They're so cute I could just pinch their little CIM motors!:D :p - Akash Rastogi [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| They're so cute I could just pinch their little CIM motors!:D :p - Akash Rastogi [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Quick XRP question.
Does anybody know roughly how long the whole DeWalt XRP tranny and CIM motor assembly is?
|
|
#2
13-03-2006, 21:13
|
||||
|
||||
|
Re: Quick XRP question.
Although I don't have the exact dimensions on me, I can tell you that the Dewalt transmissions that my team built are between ten and twelve inches long. Perhaps I can get you a measurement tomorrow from one of our spares.
|
|
#3
13-03-2006, 21:34
|
|||||
|
|||||
|
Re: Quick XRP question.
Had you asked me friday, I could've just taken the measurement. As I recall, the assembly is something around 8 inches long.
|
|
#4
14-03-2006, 10:46
|
|||
|
|||
|
Re: Quick XRP question.
from the edge of the threads on the nose to the back of the cim is just about 9.5"
make sure you leave a little space behind the cim for the wires tho, since they come out the bottom |
|
#5
15-03-2006, 17:05
|
||||
|
||||
|
Re: Quick XRP question.
Thanks for the info.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quick Question 2 | Minitruck1506 | Chit-Chat | 0 | 22-02-2006 16:17 |
| Quick Timer Question | et1337 | Programming | 3 | 02-02-2006 15:19 |
| Just A Quick Question | Mike371 | General Forum | 4 | 25-03-2003 14:25 |
| Quick <hr> question | Jack | Website Design/Showcase | 1 | 31-01-2003 22:19 |
| A quick question | Joelster | Technical Discussion | 6 | 10-02-2002 09:09 |
Hybrid Mode
