|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Electrical tape as a non-functional decoration
Is the use of electrical tape as a non-functional decoration legal?
We drew designes on the side of our robot in it, and were told that it was against the rules... Can we do so at nationals? |
|
#2
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
Personally, I would be concerned that the tape would loosen and fall off the robot. Electrical tape isn't all that known for its adhesive abilities, particularly in the heat on the field, and you wouldn't want your robot making a trail as it drove. What about paint or some other decoration like that?
|
|
#3
|
||||
|
||||
|
Re: Electrical tape as a non-functional decoration
Quote:
p.s. good job yesterday. it was fun! ![]() |
|
#4
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
Thanks... Good job to you guys too.
and to the tape falling from the robot thing, we went throught the entire pittsburgh regional with it on there and none came off... |
|
#5
|
||||
|
||||
|
Re: Electrical tape as a non-functional decoration
i also found this:
Quote:
Last edited by AV_guy007 : 02-04-2006 at 17:10. Reason: grammar |
|
#6
|
||||||
|
||||||
|
Re: Electrical tape as a non-functional decoration
Quote:
|
|
#7
|
||||
|
||||
|
Re: Electrical tape as a non-functional decoration
now that i see that i am not sure. i would ask a first official who has a very good understanding o the rules
|
|
#8
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
We used electrical tape on our helix to make the whole thing look black and nobody said anything, so I think it's okay.
|
|
#9
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
Quote:
The Philly Lead Inspector was the one who told you to take the tape off and he was correct in doing so. It is not legal. I should have noticed that tape at Pitt (although I only checked off your firmware upgrade) and told you to take it off then. It is not even legal to use tape to hold your logos on the bot and that is difficult for many teams. <R33> allows you to use tape only where it is necessary and if it was allowed as a decoration it would be used inappropriately but legally. |
|
#10
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
Ok... Thanks
We will find another medium to use for the lines... be it sharpie or paint or "decorative stripping"... thanks for the clarification ![]() |
|
#11
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
Interesting. We've always wondered about this, because we've used tape as decorations for the past two years. Last year it was for numbers and this year it was on the top of our hopper (which is clear) so that we could see the top easily. Both passed inspection. When in doubt however, you could always just use foam tape
|
|
#12
|
|||
|
|||
|
Re: Electrical tape as a non-functional decoration
I've always thought the FIRST rules have been pretty clear on this although pretty anal. However, it's always been a bit annoying to get to the competition and see that most inpectors seem to ignore it. Another peeve in the same vein is the robot numbers. A good number of robots don't conform to the rules specifying how the numbers are to be displayed yet are passed by the inspectors.
|
|
#13
|
|||
|
|||
|
Re: Electrical tape as a non-functional decoration
I was reading the inspection manual and just ran across this:
Code:
page: 6 of 23 ... Specifically prohibited mechanical parts ... 6) Electrical tape used for any objective other than insulation |
|
#14
|
|||||
|
|||||
|
Re: Electrical tape as a non-functional decoration
Quote:
Inspectors have allowed the use of electrical tape to satisfy the team number requirement for many years. Hence the requirement that the team numbers have a 3/4" stroke and be at least 4" high. In all other cases, the rules apply to electrical tape use for insulation. |
|
#15
|
||||
|
||||
|
Re: Electrical tape as a non-functional decoration
We put electrical tape around the edges of our lexan sides when the judges said that they were a bit too sharp. They let it slide, but they said that they really didn't like it. After our next match we took it all off and used sandpaper to smooth down the edges.
My point is, even if you may be able to get through inspection by going a tad outside the rules, you should try not to. The rules are there for a reason, so you should try to obey all of them. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Legality of using Tape for Labels? | Goobergunch | Rules/Strategy | 7 | 18-02-2005 01:35 |
| Duct Tape | yamo18 | Rules/Strategy | 10 | 14-12-2004 19:08 |
| Electrical Tips for Rookies | Anne Shade | Technical Discussion | 15 | 03-12-2004 12:08 |
| Hot Glue/Electrical Tape | Jeff Zampieron | Electrical | 7 | 25-02-2004 03:52 |
| How is reflective tape applied to HP crates? | Dr.Bot | General Forum | 2 | 06-01-2003 15:17 |