|
|
|
 "Is it possible to cut enough holes in the robot to weight reduce 8 lbs?" - ScoutingNerd175 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "Is it possible to cut enough holes in the robot to weight reduce 8 lbs?" - ScoutingNerd175 [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
pic: 114 gearbox design
|
|
#2
04-12-2006, 15:21
|
|||
|
|||
|
Re: pic: 114 gearbox design
Is this meant for direct drive? It would be cool if you mounted a wheel inside your transmission.
I just assumed that since you already know how fast it will be going you'd know what wheels you will be using.
|
|
#3
04-12-2006, 20:38
|
|||
|
|||
|
Re: pic: 114 gearbox design
It's output shaft hasn't been made yet, but it will be keyed to the center wheel. The wheel diameter is 4".
|
|
#4
05-12-2006, 03:36
|
|||||
|
|||||
|
Re: pic: 114 gearbox design
Looks great!
Is this a shifter, perhaps a Ball-Lock?
|
|
#5
05-12-2006, 19:53
|
|||
|
|||
|
Re: pic: 114 gearbox design
I might be adding a ball lock stage to this, but currently it's a single speed.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Team 188 Woburn Robotics 2004 Gearbox Design Report | CD47-Bot | Extra Discussion | 5 | 17-03-2009 18:45 |
| pic: 114 wheels | CraigHickman | Robot Showcase | 12 | 31-01-2006 15:50 |
| How to design a gearbox? | Hinkel Y. | Technical Discussion | 14 | 07-04-2004 23:06 |
| A question about gearbox design . . | Frank(Aflak) | Technical Discussion | 14 | 02-10-2003 14:57 |
Hybrid Mode
