cam not working with CMUcam2GUI

itay_ms · #1 21-01-2007, 06:47

im connecting the cam to the computer and in the CMUcam2GUI but the softwere noy found the cam

Daru · #2 21-01-2007, 11:55

Make sure the backup battery is fully charged, make sure the camera is plugged into the PWM but IS NOT plugged into the TTL. Make sure the camera is on. Should work!

slloyd · #3 21-01-2007, 14:26

you also need to plug a DB9 cable between your camera and the back of your PC.

with these cameras you can either view the picture of the captured video (via the DB9 connector) ... OR ... use the TTL converter and no DB9 to track a green light.

eh?

The yellowdart · #4 21-01-2007, 15:17

also make sure that your computer is reading the port used that it is connected to and select the right port.

When you plug it into the camera, go to control panel --> System --> Hardware --> device manager look at the COM and ports and see where its plugged in. You have to tell the GUI where to look for the camera.

Bomberofdoom · #5 22-01-2007, 07:59

Ok, we got the GUI working, did grab frame etc. What are we supposed to do now?

Mark McLeod · #6 22-01-2007, 10:58

Just use it to focus the camera.
You can also see and measure the camera's field of view for yourselves.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CMU Cam not Tracking Properly on Robot	coastertux	Programming	6	29-01-2006 00:02
cam not working :(	magical hands	Programming	3	05-02-2005 21:45
CMUCam not working	Inverted	Programming	10	04-02-2005 19:32
Radios not working...	E Jones 234	Electrical	3	21-01-2005 21:58
CMUCam not working.	Matt Krass	Programming	4	18-01-2005 14:08