|
|
|
 "Don't make me call my flying monkeys..." - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "Don't make me call my flying monkeys..." - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Ringer Dimensions
ARENA Section 6.3 says, "When inflated, each GAME
PIECE is approximately 32 inches across the outer diameter. Each toroid has an inner diameter of approximately 13 inches, and a height of approximately 9-1/2 inches." Is anyone else having trouble that the ringers supplied in the KOP don't match the dimensions shown? Ours measure 8.5" height. |
|
#2
21-01-2007, 14:18
|
|||
|
|||
|
Re: Ringer Dimensions
We had a similar problem until we pumped our tubes up to the maximum PSI. At 2.5 PSI the tubes measure a perfect 9 1/2 by 9 1/2 inches.
We filled the tubes to this pressure using a sensitive pressure gauge and the KOP compressor. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Full Scale Prototype Ringer Arm 2007 | lynca | Extra Discussion | 5 | 20-01-2007 00:25 |
| pic: Ringer Supported by Both Spider and Stinger | Nate Laverdure | Extra Discussion | 7 | 17-01-2007 15:45 |
| Ringer pressure | Seki | Technical Discussion | 2 | 12-01-2007 19:13 |
| pic: 2 ringer spacing | Ryan Foley | Extra Discussion | 3 | 07-01-2007 01:31 |
| pic: Spoiler and Ringer on top leg 2 | Ryan Foley | Extra Discussion | 1 | 07-01-2007 01:25 |
Hybrid Mode
