cmu cam pwms

seanl · #1 27-01-2007, 23:09

hi im using kevin's "bells and whistles" version 2.1
does any one know the pwm outputs for the pan and tilt,
and one more question where do i get power to the camera, i think its through pwm, if it is which pwm do i plug it in to

jgannon · #2 27-01-2007, 23:19

By default, pan is PWM01, and tilt is PWM02. The power for the camera does come from the PWMs... you can put it on any one you aren't using.

seanl · #3 27-01-2007, 23:21

alright cool thanks.

jdejoannis · #4 29-01-2007, 11:49

The wiring is explained in the CMUCam2 Workbook under Section 5 for MPLAB. For EasyC, I understand that the PWM's may be different.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CMU cam	Booger	Programming	3	18-07-2006 00:00
CMU Cam on an EDU-RC	Redneck	Programming	2	11-02-2006 14:55
CMU-Cam power	QuantumNinja	Programming	1	01-02-2006 21:14
CMU CAM setup	stephenthe1	Programming	0	17-01-2006 11:36
CMU Cam GUI	Arc736UV	Programming	2	15-03-2005 19:26