pic: team 932

Charger_07 · #1 03-02-2007, 18:24

dtengineering · #2 03-02-2007, 18:26

Looks nice. It looks like you have the 2xCIM adaptor for the Banebots gearboxes. Have you had a chance to drive it around yet and check for increasing backlash in the tranny?

Jason

Charger_07 · #3 03-02-2007, 19:30

thanks, its getting there despite us losing a week to ice.....no we havent driven it yet, everytime we are about to wire it up to drive, something goes wrong in the gearbox but we fixed it finally

Sam Cat · #4 07-02-2007, 11:50

That's a good-looking robot. It's hard to tell from the picture how the manipulator is attatched to the arm. Does the manipulator stay parallel as you lift it, and if so, how? It looks to me like the manipulator section pivots freely at the point where it attaches to the arm.

Charger_07 · #5 07-02-2007, 16:21

thanks...this is just sort of a prototype as far as the arm goes, we just used some materials that we had laying around...the end of the arm will look different when we are done

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Team 932	Charger_07	Robot Showcase	5	02-02-2007 13:59
pic: Team 932 robot	Charger_07	Robot Showcase	6	28-01-2007 19:59
Team 932 video	Charger_07	Robot Showcase	2	22-02-2006 18:46
Team 932 shooter video	Charger_07	Robot Showcase	2	14-02-2006 22:29
Team 932 animation	Ydnar	3D Animation and Competition	10	21-03-2002 22:06