|
|
|
 Winning the robot part of the competition is not about learning or doing unneccesary work. It works just like "winning" in industry. - Max Lobovsky [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Winning the robot part of the competition is not about learning or doing unneccesary work. It works just like "winning" in industry. - Max Lobovsky [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
REQUEST: Banebots 42mm 256:1 at LoneStar
If anyone coming to the Lonestar regional has a BB 256:1 tranny that they're no longer using, 57 would like to trade for it or otherwise acquire it.
57 has been repairing and strengthening our Banebots transmissions, and in the process, I have made a slight slip-up. The ring gear as purchased is about .055 too long. This results in very poor engagement of the double-D joint. In machining down the ring gear on a transmission, I managed to take off a bit too much, and now the tranny binds slightly if I leave the rear thrust washer in. I can work around this in various ways, but I'd rather start fresh with one more ring gear if anyone has one to spare. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Banebots 42mm gearbox: Recommendations for use | Joe Johnson | Motors | 61 | 01-04-2007 15:28 |
| Banebots 42mm grease? | Kevin Sevcik | Motors | 2 | 23-03-2007 19:23 |
| 42 mm, 256-1 Banebots Available yet? | JB987 | General Forum | 2 | 09-02-2007 22:45 |
| BaneBots 42mm Gearbox Pinion | Gary Bonner | Motors | 1 | 31-01-2007 13:44 |
| Thanks teams 256, 60, 359, 636 | archiver | 2001 | 0 | 24-06-2002 02:46 |
Hybrid Mode
