pic: 114: How we roll

loading photo ...

[JoelP]

Single bolt tensioner system? Sounds interesting, how'd you do that? and what's the CoF of that nitrile stuff?

[sanddrag]

I like the blue roughtop stuff. We use it. Drives pretty nice. And about 45 matches worth of driving and it is holdng up just fine. Not even close to getting worn out.

Just curious, why did you chose to go to dead axles? (or so it appears).

[CrosbyAR]

where did you get that blue nitrile tread?

-Alex

[Rich Ross]

I'd like to know the CoF on that too. Any chance on a paper with the gearbox? Nice job on a sweet drive.

[Lil' Lavery]

Nitrile rough-top has essentially equivalent CoF to rubber rough-top, both about 1.3. 116 purchased our nitrile from McMaster, and I'd assume 114 did as well (only source I know of).

[robostangs548]

Rollin of fo's thats totally sick baller yo! Are they chrome? Next year we are thinking of getting anything that can be chrome dipped, chrome dipped. So we can have a "bling bling" robot..... We are also working on a ball bearing spinner idea.. We will tell you how that goes....

[ChrisMcK2186]

impressive, my team needs to learn how to build a drive train.

Chris

Originally Posted by JoelP

Single bolt tensioner system? Sounds interesting, how'd you do that?

Our outer shafts are mounted in two bearing blocks inside a milled out pocket in the 2x1 frame bars, and the bearing blocks are linked via a plate on standoffs. From a plate at the front of the drivetrain, a bolt goes back to the linking plate, and can be tightened to pull the chain. Look here: http://www.chiefdelphi.com/media/photos/27585
You can kinda see the tensioner at the bottom corner.

Originally Posted by sanddrag

Just curious, why did you chose to go to dead axles? (or so it appears).

The axles are live, with an eighth inch key in them. They sit in bearing blocks that are pulled to tension the sytem.

Originally Posted by CrosbyAR

where did you get that blue nitrile tread?

McMaster. It's blue nitrile, food grade conveyor. We love the stuff.

Originally Posted by Rich Ross

Any chance on a paper with the gearbox? Nice job on a sweet drive.

I'm not too good at making papers. However, these transmissions may soon be sold from Trossen Robotics, in a partnership with Outback Manufacturing. Keep an eye out.

[Lil' Lavery]

Originally Posted by 114ManualLabor

McMaster. It's blue nitrile, food grade conveyor. We love the stuff.

It's actually not, just on the same page as the food grade conveyors. The nitrile is incline belting.

Originally Posted by Lil' Lavery

It's actually not, just on the same page as the food grade conveyors. The nitrile is incline belting.

Bah, same difference. We love INCLINE BELTING then...

But yeah, it only slightly wore down, and only on the middle wheels. I have a feeling the wear was because of our ability to score extremely well, and so we were targeted with heavy defense the whole time...

[Joel J]

Originally Posted by Lil' Lavery

Nitrile rough-top has essentially equivalent CoF to rubber rough-top, both about 1.3. 116 purchased our nitrile from McMaster, and I'd assume 114 did as well (only source I know of).

Woah.. did you test to verify that?

Nitrile isn't as grippy as the SBR roughtop, as far as I can remember. In fact, there is a noticeable different upon inspecting both of them.