|
|
|
 FIRST has stated time and again that the program is not about teaching (they always refer to the I and R in FIRST) - Dave Flowerday [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST has stated time and again that the program is not about teaching (they always refer to the I and R in FIRST) - Dave Flowerday [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Globe Motor Connection
I am interested if anyone can give me insight on how to connect an axel or gear (sprocket) to the 117:1 Globe motor gearbox setup in the 2008 KOP.
Thanks! |
|
#2
07-01-2008, 22:57
|
||||
|
||||
|
Re: Globe Motor Connection
Since the shaft has flats on it, it shouldn't be hard to setscrew a gear or sprocket on. All of the #25 and #35 finished sprockets that McMaster carries have set screws in them.
|
|
#3
08-01-2008, 03:03
|
||||
|
||||
|
Re: Globe Motor Connection
Hey zak I made a few ways u can connect to the globe motor on a 3Dplastic printer. ill bring them in tomorrow for ya.
(edit) here is one of them, the only play u can feel is play the motor has. http://www.netblues.org/tim/globe.jpg Last edited by Valkyries_698 : 08-01-2008 at 03:48. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Window Motor electrical connection | Andrew Schuetze | Motors | 8 | 14-02-2006 09:58 |
| Parallel Motor Connection | Don Wright | Electrical | 12 | 30-03-2004 21:23 |
| window motor connection | albertgates | General Forum | 1 | 12-02-2003 17:18 |
| Globe Motor | archiver | 2000 | 4 | 24-06-2002 00:15 |
| Globe Motor | archiver | 2000 | 0 | 24-06-2002 00:15 |
Hybrid Mode
