LINKING ERRORS!!!

AHepperla · #1 14-01-2008, 21:17

Hey guys, when we compile our code in EasyC, we get a linking error and the error says: Error- section '.code_u2open.o' can not fit the section. Section '.code_u2open.o' length=0x00000064. We're dividing with floats and that seems to be the problem because it works with ints. Any ideas???

Mark McLeod · #2 14-01-2008, 23:22

You've run out of Program Memory on the controller.

JonathanLKS · #3 15-01-2008, 18:46

If you need those decimals, you could just scale them up by a few factors of ten so you can use ints, divide, then scale it back down.

It'll be faster too.

Kevin Sevcik · #4 15-01-2008, 23:36

Quote:

Originally Posted by JonathanLKS

If you need those decimals, you could just scale them up by a few factors of ten so you can use ints, divide, then scale it back down.

It'll be faster too.

Scale up by factors of 2. Then you can use << instead of *. It's a heck of a lot quicker. You still have to divide unless you're using unsigned ints, however.

AHepperla · #5 19-01-2008, 10:00

Alright thanks guys, helped a lot and we're back on track now!!!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
linking error	Turdmoe	Technical Discussion	2	27-01-2007 19:01
Error Linking for '05 RC	Jon236	Programming	2	12-02-2006 14:30
A linking problem	T Shap	Programming	6	15-01-2006 00:23
Linking Errors: "section '????' can not fit the section. ..."	Astronouth7303	Programming	3	16-01-2005 21:36
Dynamic Linking with PHP	plutonium83	Website Design/Showcase	6	12-01-2005 19:41