|
|
|
 Can you restate your observation in a manner that reconciles with physics? - Madison [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Can you restate your observation in a manner that reconciles with physics? - Madison [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
Code not changing robots function!
Hello,
I was writing some simple code to control the robot feedback LED's on the O/I and whenever i change the code then compile it and program it in, it never changes what the O/I does... So i programed in some drive functions to the robot (other than the default) and they didn't work either... however if i go to a different computer and open it from the network and compile it then upload it it works!?  But if it is compiled on the computer that it is saved on.... It will not work!!IM SO CONFUSED! Any sugestions? |
|
#2
23-01-2008, 23:35
|
|||||
|
|||||
|
Re: Code not changing robots function!
Are you absolutely 100% sure that you are loading the exact code you compiled? including the correct hex file name?
|
|
#4
25-01-2008, 11:17
|
||||
|
||||
|
Re: Code not changing robots function!
Make sure that the default code that turns on the LEDs is commented out (it's in the slow loop) since that will most likely override any of your code that you wrote.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Encoders not changing... | paulcd2000 | Programming | 28 | 18-02-2007 08:34 |
| Changing Code Formatting in MPLAB!!! Yeah!!! | Astronouth7303 | Programming | 1 | 09-03-2004 18:07 |
| Changing 1 joystick code to 2 (rookie team) | Brawler006 | Programming | 5 | 20-02-2004 17:00 |
| Square Root Function not working | bludstayne | Programming | 7 | 15-02-2004 12:09 |
| Curie Division Robots information... (not complete) | archiver | 2001 | 3 | 24-06-2002 03:13 |
Hybrid Mode
