Use of 1-1/2" bore actuator

VEN · #1 30-01-2008, 14:05

Are we allowed to use 1-1/2" bore 90 degree pneumatic actuators from bimba?

EricH · #2 30-01-2008, 14:38

Quote:

Originally Posted by VEN

Are we allowed to use 1-1/2" bore 90 degree pneumatic actuators from bimba?

Is it on the order form? If no, then no. If yes, then yes.

IndySam · #3 30-01-2008, 15:34

No you can only use the 3/4 inch actuator on the order form. It can be useful but at 60psi it is kind of week.

VEN · #4 30-01-2008, 16:40

Thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3/4" bore x 1/2" stroke Bimba Cylinder model	sanddrag	Inventor	5	16-01-2006 22:14
Team 1511 video "learning how to use a alenwrench"	Mirza95vx	Robot Showcase	2	05-02-2005 17:36
24" Stroke 1.0625" Bore Piston Legality	Yan Wang	Pneumatics	4	05-02-2005 09:32
Need Inventor model 3/4" Bore Cylinder Quick	sanddrag	Inventor	1	05-04-2004 00:40
2" Bore Piston Threads	Madison	Technical Discussion	7	29-01-2002 22:35