Need Help

kijj · #1 31-01-2008, 23:31

I have a problem with the default user code for EasyC Pro, the problem is that when i Build & Download the code onto the Robot Controller i plug the Victors PWM, into Digital In/Out port 1 and the other victor's PWM into Digital In/Out port 2 i try to control the robot with the joystick and the PWM light on the Operator Interface turns green if the joystick is moved forward and red if backwards but the main drive motors do not run and the victors LED keep flashing Yellow but if i plug the PWM into the PWM output the motor constantly runs without the LED on and the spike relays work on the relay outputs please help.

popo308 · #2 31-01-2008, 23:54

Quote:

Originally Posted by kijj

I have a problem with the default user code for EasyC Pro, the problem is that when i Build & Download the code onto the Robot Controller i plug the Victors PWM, into Digital In/Out port 1 and the other victor's PWM into Digital In/Out port 2 i try to control the robot with the joystick and the PWM light on the Operator Interface turns green if the joystick is moved forward and red if backwards but the main drive motors do not run and the victors LED keep flashing Yellow but if i plug the PWM into the PWM output the motor constantly runs without the LED on and the spike relays work on the relay outputs please help.

the victors plug into the PWM out's not digital

kijj · #3 04-02-2008, 00:46

Thank you that helpedhttp://www.chiefdelphi.com/forums/images/smilies/biggrin.gif

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need help assembling parts in inventor .. (was: help)	jhallel	Inventor	5	22-02-2007 01:46
hey need some help with writing a code please help me here	magical hands	Programming	9	01-01-2004 21:46
HELP!! i need help starting a new team!!	shyra1353	Starting New Teams	18	07-10-2003 17:55