|
|
|
 I'm thinking they subscribe to the thought that "the best offense is a good defense". They are from New England, after all. - Travis Hoffman [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm thinking they subscribe to the thought that "the best offense is a good defense". They are from New England, after all. - Travis Hoffman [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||||
|
||||||
|
CIM Motor Differences
We are using Two Dual CIM motor and banebots transmissions (like last year) for our drivetrain this year, and are noticing some problems with the robot severly curving to the right (seemed more than normal). We replaced a bad bearing and fixed some overgrease in it, but are now thinking we might have a motor issue as well.
My question is, does anyone have any exact tested data on how fast the CIM motors by themselves in the forward vs. reverse directions? I know there should be a difference, but in trying to isolate our problem we didnt know how much of a difference, and thought someone might have already run the tests and be able to save us a little time. Thanks!! |
|
#2
07-02-2008, 14:36
|
|||||
|
|||||
|
Re: CIM Motor Differences
In my experience, the differences is only about 100-200rpm.
|
|
#3
07-02-2008, 14:41
|
|||||
|
|||||
|
Re: CIM Motor Differences
See this thread kim
http://www.chiefdelphi.com/forums/sh...t=41255&page=2 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| FP motor differences | Devo1098 | Motors | 3 | 22-06-2007 06:52 |
| CIM motor gearbox | tseres | Motors | 3 | 22-05-2007 22:31 |
| dewalt motor VS. CIM motor | John Gutmann | Motors | 12 | 10-01-2007 18:57 |
| Large Cim Motor? | Fishdude404 | Motors | 1 | 27-01-2006 22:36 |
Hybrid Mode
