|
|
|
 4's company, 5's a crowd, and 6 is someone off-sides. - HyPhire111 [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| 4's company, 5's a crowd, and 6 is someone off-sides. - HyPhire111 [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
07-02-2008, 20:27
|
||||
|
||||
|
Re: broken ir input
Post a bit of your code. The IR sensors sends a 1 instead of a 0 when it is lit unlike a lot of other sensors.
|
|
#3
08-02-2008, 11:05
|
|||||
|
|||||
|
Re: broken ir input
If your other IR inputs are working then I'd suspect a bad connection for IR digital output 1.
Since you've tried moving it to different RC input pins, maybe it's one end or the other of the ribbon connector. Does the battery you are using power both the RC and the IR board? If you use different batteries then the code will get different results. Last edited by Mark McLeod : 08-02-2008 at 11:10. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Broken O/I | NumberQ | Robotics Education and Curriculum | 10 | 01-10-2004 16:06 |
| Broken robots | Tytus Gerrish | Technical Discussion | 12 | 29-09-2004 20:46 |
| CD is broken. | Rickertsen2 | CD Forum Support | 62 | 26-10-2003 13:06 |
| 2.5 is alive !!!! (input ! .. more input ! ) | Lloyd Burns | Programming | 2 | 14-01-2003 19:15 |
| Broken promises or BROKEN ROBOTS! | archiver | 1999 | 9 | 23-06-2002 22:18 |
Hybrid Mode
