|
|
|
 We need to start building FIRST competition arenas and leasing them in the off-season to the sports teams and conventions ;) - protoserge [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We need to start building FIRST competition arenas and leasing them in the off-season to the sports teams and conventions ;) - protoserge [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
programming
I recently downloaded the V7 master code with easy C V2. My robot will not go out of autonomous mode. If I put a jumper in interupter 6, it goes to operator control, however it does not exit out of autonomous mode under normal circumstances. I had the controller on when I tested this, and it still does not work. Please help. Thanks.
|
|
#2
08-02-2008, 20:55
|
|||
|
|||
|
Re: programming
I figured it out. Turns out I had the wrong version of the master code V7. It works now though.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming in Python and Explaination of Programming | roboxking | Programming | 22 | 07-01-2008 16:08 |
| programming motors with programming kit | BorisTheBlade | FIRST Tech Challenge | 4 | 01-11-2005 19:03 |
| Programming | Gusman1188 | Programming | 5 | 17-02-2003 11:23 |
| programming | great_one411 | General Forum | 0 | 15-02-2003 11:46 |
Hybrid Mode
