|
|
|
 If there's one thing I've learned, it's that the robot is never truly finished. - Joseph Smith [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If there's one thing I've learned, it's that the robot is never truly finished. - Joseph Smith [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Legal Pneumatics Cylinders
While reviewing our final design and elements after build, my team found out that we accidentally used an illegal pneumatic cylinder of 1.25" bore and 1" throw. Since we can only use cylinders that came in the KOP or were in the Free Pneumatics Form from Bimba and Parker, I need to know what the different throw options that were posted on the site. I know that the legal bore sizes are 3/4", 1 1/2", and 2", and we will probably end up with 1 1/2 bore cylinder as a replacement. Does anybody know the legal throws for a 1 1/2 bore cylinder?
|
|
#2
27-02-2008, 22:11
|
|||||
|
|||||
|
Re: Legal Pneumatics Cylinders
It's listed on the last page of the Pneumatics Manual, found the same place you find the rest of the FRC manuals.
|
|
#3
27-02-2008, 22:12
|
|||||
|
|||||
|
Re: Legal Pneumatics Cylinders
Check out the last page of this document:
http://www.usfirst.org/uploadedFiles...ics_Manual.pdf That is the form that lists the cylinders that were offered. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 position cylinders from bimba, legal??? | cdennisxlx2 | Pneumatics | 8 | 28-01-2007 12:09 |
| buying cylinders | 1574aviad | Pneumatics | 1 | 07-02-2006 14:32 |
| Spinning Cylinders | Rick TYler | Technical Discussion | 5 | 04-02-2006 02:36 |
| Pneumatic Cylinders | MASherry | Pneumatics | 1 | 09-01-2005 18:49 |
| Air cylinders | archiver | 2000 | 1 | 24-06-2002 00:14 |
(since 2004)
Hybrid Mode
