Problem with Scatter

addictedMax · #1 07-01-2009, 00:29

I need to scatter an object onto another object but I need it so that its always facing at a 90 degree angle from the object with the end on the outside of the object. Scatter wont do that for me

BuddyB309 · #2 07-01-2009, 08:52

check mark the box, perpendicular to face. Sometimes scatter causes many problems. Sometimes you have to bite the bullet and do it yourself.

Mazin · #3 30-01-2009, 11:33

Select the source object and rotate the xform gizmo.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with Penalties	XaulZan11	General Forum	41	28-05-2008 06:47
Problem with unwired RC-OI	itsme	Technical Discussion	9	18-01-2007 08:09
Problem with MPLAB	d.courtney	Programming	5	02-02-2005 21:42
Problem with communicating with STAMP through serial port	Skabana159	Technical Discussion	2	06-02-2003 21:10
Problem with OI / RC	Jay Lundy	Technical Discussion	2	29-03-2002 23:07