Timing with the Driver Station

Zorkinian · #1 09-01-2009, 14:16

Does anybody know the rate at which packets arrive at the cRIO from the driver station? Is it a constant?

whitetiger0990 · #2 09-01-2009, 17:47

I can't find anything specifically, but I would say it is not constant. It's a TCP stream as far as I am aware.

You probably shouldn't depend on DS packet timing, but instead use a different timer which you can control.

mgurgol · #3 09-01-2009, 17:51

Is there a way to calculate delta time in Labview?

Zorkinian · #4 09-01-2009, 19:30

There may be a way, though I haven't tested it. Under Real-Time -> Real-Time Timing there is a tick count (presumably of the processor) that you read from, which you can also set to mSec or uSec, which would probaby get you the resolutino you need.

whitetiger0990 · #5 09-01-2009, 23:25

Under Timers, use Tick Count. It's millisecond resolution so it should be enough. Then just save the value through whatever method you want and subtract from the current Tick Count whenever you want the delta.

tdlrali · #6 09-01-2009, 23:37

50Hz (it's in the headers if you look)

mgurgol · #7 10-01-2009, 09:42

Thanks for the info on delta time, I'll create a shift register.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with updating firmware on Driver Station	urg8rb8	FRC Control System	3	28-12-2008 02:53
Securing the Driver Station?	Madison	FRC Control System	16	16-12-2008 03:05
Mounting the Driver Station...?	1708xMr.Roboto	FRC Control System	1	15-12-2008 12:34
pic: The new driver station	Billfred	Extra Discussion	28	23-04-2008 20:07
pic: Why FIRST needs to make the driver station taller	Jay Trzaskos	Extra Discussion	12	12-03-2007 08:57